TVs, Printers, microwaves, chargers, DVD players, desktop computers and many other devices all drain energy when turned off or not in use. This drain is known as ‘vampire’ or ‘standby’ power and is responsible for a huge amount of energy loss each year. Since that energy is largely generated by burning fossil fuels, vampire power accelerates the rate of global warming as well as raising your electricity bill.
According to UC Berkeley, Americans lose 200-400 terawatt hours per year to vampire power; that’s enough electricity to power all of Italy! That is quite something, given that the US population is only about 5 times larger than that of Italy. Some investigations into vampire power have found that many appliances actually use more energy during the time when they are idle than they do when they are in use. One survey of office buildings in Thailand found that 90% of the electricity used by printers, copiers and fax machines was vampire power. In other words, it would cost 10 times less money and emissions to run these devices if they were simply unplugged when not in use. Another study found that 80% of electricity used by video recorders in Australia was used in standby mode.
So how can you identify an energy vampire? Unfortunately it is not as simple as throwing holy water at your devices. There are, however, some good rules of thumb. Anything that can be turned on with a remote control is likely an energy vampire, since the sensor which picks up the signal must remain on 24/7. Another likely culprit is any device, like microwaves or radios, which constantly displays the time on a screen. There are, however, many other devices which consume power when not in use but show no external signs of doing so.
This issue negatively affects both the bank accounts of the average consumer and the global effort to combat climate change. Compared to dismantling the fossil fuel industry or convincing everyone to stop eating meat, this is a relatively easy fix. One way to slay vampire power is on the side of the consumer. If you buy a couple of extension cords with on/off switches, you can easily cut power to things like TVs and printers when they are not in use. Try keeping your remote control beside the extension cord so that you can flip the switch when you go to pick it up. There is, however, only so much we can do.
The more promising solution to vampire power is technical and is the responsibility of electronics manufacturers. For example, energy-saving devices can be built which automatically cut power when not in use for a certain amount of time. Another example would be phone or laptop chargers which cut the power when the device is fully charged or unplugged. It is estimated that changes to the power circuits of devices could reduce vampire power by as much as 90%, so manufacturers have the power to largely fix this issue all by themselves. One problem with this is that consumers are more likely to buy, for example, a TV which can be turned on remotely, so manufacturers have an incentive to keep producing goods which drain power when not in use.
Cutting vampire power would allow us to supply many more people with electricity without a corresponding increase in CO2 emissions. Improvements in efficiency such as this will be necessary to fight climate change, but must occur in tandem with a number of other tactics, including a conscious effort to reduce energy consumption across the board. It is the responsibility of manufacturers and consumers alike (but mainly manufacturers) to be careful about how much power is being used, and to identify and eliminate any power drain which is not absolutely necessary.